Cisco Systems PA-2H manual Port adapter retention clip in locked position

Models: PA-2H

1 62
Download 62 pages 42.49 Kb
Page 43
Image 43

Replacing a Port Adapter

Figure 6-6 Placing the Port Adapter Retention Clip in the Locked Position (Cisco uBR7246 Shown)

Port adapters

H11517

Port adapter retention clip in locked position

For a Cisco uBR7223, place the port adapter lever in the locked position. (Refer to Figure 6-7.)

Figure 6-7 Placing the Port Adapter Lever in the Locked Position (Cisco uBR7223 Shown)

Port adapters

Port adapter lever in locked position

16177

Note If the port adapter lever does not move to the locked position, the port adapter is not completely seated in the midplane. Carefully pull the port adapter halfway out of the slot, reinsert it, and move the port adapter lever to the locked position.

This completes the procedure for installing a new port adapter or replacing a port adapter in a Cisco uBR7200 series router. To install the necessary cables and configure your HSSI port adapter, proceed to “Chapter 7, “Cable Installation and Interface Configuration.”

Cisco uBR7200 Series and the Dual-Port HSSI Port Adapter 6-5

Page 43
Image 43
Cisco Systems PA-2H manual Port adapter retention clip in locked position