Cisco Systems PA-2H manual Catalyst RSM/VIP2 show Commands

Configuring the HSSI Interfaces

Use the show controllers cbus command to display all the current interface processors and their interfaces. Following is an example of the show controller cbus command that shows the HSSI port 1/0/0 on a PA-2H HSSI port adapter installed on a VIP2 in interface processor slot 1:

Router# show controllers cbus

(additional displayed text omitted from this example)

slot1: VIP2, hw 2.3, sw 21.40, ccb 5800FF40, cmdq 48000090, vps 8192 software loaded from system

IOS (tm) VIP Software (SVIP-DW-M), Released Version 11.1(12)CA1 [biff 103] ROM Monitor version 17.0

HSSI-B(1) HW Revision 0x2, FW Revision 2.42 Hssi1/0/0, applique is Hssi DTE

received clockrate 51838976

gfreeq 48000160, lfreeq 48000200 (4480 bytes), throttled 0 rxlo 4, rxhi 258, rxcurr 0, maxrxcurr 0

txq 48001A80, txacc 48001A82 (value 129), txlimit 129

(additional displayed text omitted from this example)

Note For complete VIP2 command descriptions and examples, refer to the documentation resources listed in the “If You Need More Information” section on page vii.

Proceed to the section “Using the ping Command” to verify that each interface port is functioning properly.

Catalyst RSM/VIP2 show Commands

Caution If you are using the HSSI dual-port adapter in the Catalyst 5000, 5500, 5505, or 5509 switch, you must install the port adapter on the Catalyst RSM/VIP2-15 or -40 Revision 2 (board part number 73-3468-XX, where XX is the version number). Do not use the HSSI dual-port adapter in the Catalyst 5000, 5505, or 5509 switch if you are installing it on a Catalyst RSM/VIP2-15 or -40 module that is not the Revision 2. If you fail to comply with this restriction, your system will shut down due to an overload of the power supply.

Caution You can only have two HSSI dual-port adapters per chassis when installed on a

Catalyst RSM/VIP2-15 or -40 module Revision 1 and used in the Catalyst 5500 switch.

Following is an example of how the show interfaces [port-adapter/port] command displays status information (including the physical slot and port address) for the interfaces you specify. In this example, the PA-2H HSSI port adapter is in slot 0. (Interfaces are administratively shut down until you enable them.)

7-14PA-2H Dual-Port HSSI Port Adapter Installation and Configuration