C H A P T E R 6

Cisco uBR7200 Series and the

Dual-Port HSSI Port Adapter

This chapter provides information on the PA-2H dual-port high-speed serial interface (HSSI) port adapter and its use on the Cisco uBR7200 series routers.

Installation Overview

The HSSI port adapter is used in the Cisco uBR7200 series routers and can be installed in any of the available port adapter slots. Figure 6-1 shows an HSSI port adapter installed in port adapter slot 2 of a Cisco uBR7200 series router.

Figure 6-1 Cisco uBR7200 Series with an HSSI Port Adapter in Port Adapter Slot 2 (Cisco uBR7246 Shown)

ENABLED

0

TD TC RD RC LB/C

1

HSSI

 

 

PA-2H

 

0

 

 

 

 

 

 

 

 

 

port

 

 

 

 

adapter

 

 

 

 

18938

Depending on your circumstances, you might need to install a new port adapter in a Cisco uBR7200 series router or replace a failed port adapter in the field. In either case, no tools are necessary; all port adapters available for the Cisco uBR7200 series routers connect directly to the router midplane and are locked into position by a port adapter retention clip (Cisco uBR7246) or lever (Cisco uBR7223). When removing and replacing a port adapter, you will need an antistatic mat onto which you can place a removed port adapter and an antistatic container into which you can place a failed port adapter for shipment back to the factory.

Note The Cisco uBR7200 series routers support OIR; therefore, you do not have to power down the Cisco uBR7200 series router when removing and replacing an HSSI port adapter.

Cisco uBR7200 Series and the Dual-Port HSSI Port Adapter 6-1

Page 39
Image 39
Cisco Systems PA-2H manual Cisco uBR7200 Series Dual-Port Hssi Port Adapter, Installation Overview