Cisco Systems SFS 7000P, SFS 7000D manual Running Fan Self-Test, SFS-7000P-1# show diag post

Chapter 6 Hardware Diagnostic Tests

About Diagnostic Tests

Step 3 Display any errors on individual components by entering the show diag post command.

SFS-7000P-1#show diag post

======================================================================

Post Status

======================================================================

fru-slot post-status post-error

----------------------------------------------------------------------

card(1)	failed	_FRU_LIM_CARDTYPE_ERR
card(3)	failed	_FRU_SEEPROM_PROGRAM_ERR
card(5)	passed	none
card(6)	passed	none
card(7)	passed	none
card(8)	passed	none
card(9)	passed	none
card(11)	failed	_FRU_POWER_CONTROLLER_CONFIG_ERR
card(12)	passed	none
card(13)	passed	none
card(15)	passed	none
card(16)	passed	none
card(17)	passed	none
fan(1)	passed	none

Running Fan Self-Test

The procedures in this section describe the fan module tests and provide sample text from performing a fan test.

Note The sample text in the steps below shows command output for the Cisco SFS 7000P Server Switch. For the Cisco SFS 7000D Server Switch, you would see a similar display.

To perform a diagnostic self-test on a fan, follow these steps:

Step 1 Identify the number of the fan you want to diagnose, if you do not already know the number. Power supply 1 contains fan number 1, and power supply 2 contains fan number 2. (See Figure 6-1.)

Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide

6-4 OL-10853-01