Chapter 6 Hardware Diagnostic Tests
About Diagnostic Tests
Running Card Self-Test
The term cards in this section refers to fabric controllers, management I/O modules, node cards, and the chassis ID module. Fans and power supplies are not included in the card tests; they can be tested through the standard chassis test or as individual components.
The following tests are available to locate and diagnose one or more cards in the chassis:
•LED
•
The example below shows how to run a card
Note The sample text in the steps below shows command output for the Cisco SFS 7000P Server Switch. For the Cisco SFS 7000D Server Switch, you would see a similar display.
To perform a diagnostic
Step 1 Enter the diag card number command.
Step 2 Exit the test to view the progress of the test.
The test takes approximately 5 to 8 minutes.
Note You can stop the diagnostic
Step 3 Enter the show diagnostic card # command.
======================================================================
Diagnostic Tests For Cards
======================================================================
test :
iterations : 1 action : start result : success
Total=1
Step 4 If the test fails, enter the more syslog:hwif_log command to see the log information.
Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide
| ||
|