Chapter 3 Installing the Switches
Rack-Mounting the Switches
Warning Two people are required to lift the chassis. Grasp the chassis underneath the lower edge and lift with both hands. To prevent injury, keep your back straight and lift with your legs, not your back. To prevent damage to the chassis and components, never attempt to lift the chassis with the handles on the power supplies or on the interface processors, or by the plastic panels on the front of the chassis. These handles were not designed to support the weight of the chassis. Statement 5
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
•This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.
•If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. Statement 1006
This section describes how to install the Cisco SFS 7000P and SFS 7000D Server Switches in an equipment rack.
Requirements
In addition to the accessories provided with the switch, you need the following:
•A number 2 Phillips screwdriver
•8 rack screws specific to your rack
•Any associated mounting clips to secure the brackets to your rack (two for each rail of the rack)
Caution Installing the rack to the system with screws other than the ones recommended could be hazardous.
•A rack with enough clearance for the server switch cables
•Two people to perform the installation (highly recommended)
Note The Cisco SFS 7000P and SFS 7000D Server Switches weigh more than 22 pounds (10 kilograms) each.
Rack-Mounting the Switch
|
| To mount the Cisco SFS 7000P and SFS 7000D Server Switches in a rack, follow these steps: | |||
|
|
| |||
| Step 1 | Remove the switch, | |||
| Step 2 | Place the switch on a secure, clean surface. | |||
| Step 3 | Record the MAC address and the Globally Unique Identifier (GUID) number for future reference. | |||
|
| Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide |
|
| |
|
|
| |||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
| ||
