Cisco Systems SFS 7000P, SFS 7000D manual Switch Connectors, Switch Components

Chapter 1 Product Overview

Switch Connectors

Figure 1-2 Cisco SFS 7000D Server Switch

Power Supply 2

180600

Switch Connectors

The Cisco SFS 7000P Server Switch uses the following connectors:

•Twenty-four 10-Gbps 4x copper InfiniBand ports for server and interswitch connectivity

•One 10/100 Ethernet RJ-45 management-Ethernet port for out-of-band management

•One RJ-45 console port used to configure and monitor the Cisco SFS 7000P Server Switch The Cisco SFS 7000D Server Switch uses the following connectors:

•Twenty-four dual-speed 20-Gbps 4x copper InfiniBand ports that are capable of operating in either 20-Gbps DDR or 10-Gbps SDR mode for server and interswitch connectivity

•One 10/100 Ethernet RJ-45 management-Ethernet port for out-of-band management

•One RJ-45 console port used to configure and monitor the Cisco SFS 7000D Server Switch

Note There is a performance degradation if you mix 10-Gbps and 20-Gbps InfiniBand ports.

Switch Components

This section describes the following components of the Cisco SFS 7000P and SFS 7000D Server Switches and contains these sections:

•LEDs, page 1-3

•Power Supply Bay, page 1-3

•Power Supply Module, page 1-3

Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide

1-2 OL-10853-01