Chapter 1 Hardware Preparation and Installation
To remove the board from the chassis, press the red locking tabs (IEEE handles only) and reverse the procedure.
Connection to Peripherals
When the MVME3100 is installed in a chassis, you are ready to connect peripherals and apply power to the board.
Figure 1-1 on page 4 shows the locations of the various connectors while Table 1-7 and Table 1-8 list them for you. Refer to Chapter 5, Pin Assignments for the pin assignments of the connectors listed below.
Table 1-7. MVME3100 Connectors
Connector | Function |
J4 | PMC expansion connector |
|
|
J11, J12, J13, J14 | PCI mezzanine card (PMC) slot 1 connector |
|
|
J21, J22, J23 | PCI mezzanine card (PMC) slot 2 connector |
|
|
J24 | Boundary scan header |
|
|
J25 | COP header |
|
|
J27 | USB connector |
|
|
J28 | Front panel sATA connector |
|
|
J29 | Planar sATA connector |
|
|
J30 | Planar sATA power connector |
|
|
J41B | 10/100/1000Mb/s Ethernet connector |
|
|
J41A | COM port connector |
|
|
P1, P2 | VME backplane connectors |
|
|
Table 1-8. MVME721 Rear Transition Module Connectors
Connector | Function |
J1A, J1B, J1C, J1D | COM port connectors |
|
|
J2A | 10/100/1000Mb/s Ethernet connector |
|
|
J2B | 10/100Mb/s Ethernet connector |
|
|
J10 | PIM power/ground |
|
|
J14 | PIM I/O |
|
|
P2 | VME backplane connector |
|
|
MVME3100 Installation and Use (V3100A/IH1) | 9 |
