Chapter 1 Hardware Preparation and Installation

Table 1-6. EEPROM Address Settings

Device Address

A(2:0)

SW1

SW2

SW3

$A0

000

ON

ON

ON

 

 

 

 

 

$A2

001

OFF

ON

ON

 

 

 

 

 

$A4

010

ON

OFF

ON

 

 

 

 

 

$A6

011

OFF

OFF

ON

 

 

 

 

 

$A8

100

ON

ON

OFF

 

 

 

 

 

$AA (Factory)

101

OFF

ON

OFF

 

 

 

 

 

$AC

110

ON

OFF

OFF

 

 

 

 

 

$AE

111

OFF

OFF

OFF

 

 

 

 

 

Note The RTM EEPROM address switches must be set for address $AA in order for this device to be accessible by MotLoad.

Hardware Installation

Installing the MVME3100 into a Chassis

Use the following steps to install the MVME3100 into your computer chassis.

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical ground (refer to Unpacking Guidelines). The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.Remove any filler panel that might fill that slot.

3.Install the top and bottom edge of the MVME3100 into the guides of the chassis.

Only use injector handles for board insertion to avoid damage/deformation to the front

!panel and/or PCB. Deformation of the front panel can cause an electrical short or other

Warning

board malfunction.

 

4.Ensure that the levers of the two injector/ejectors are in the outward position.

5.Slide the MVME3100 into the chassis until resistance is felt.

6.Simultaneously move the injector/ejector levers in an inward direction.

7.Verify that the MVME3100 is properly seated and secure it to the chassis using the two screws located adjacent to the injector/ejector levers.

8.Connect the appropriate cables to the MVME3100.

8MVME3100 Installation and Use (V3100A/IH1)

Page 21
Image 21
Motorola Hardware Installation, Installing the MVME3100 into a Chassis, Eeprom Address Settings, Device Address A20