![Pre-installation Instructions](/images/new-backgrounds/112875/11287567x1.webp)
Chapter 3 Installing the Switches
Safety
Safety
Warning Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock,
keep hands and fingers out of the power supply bays and backplane areas. Statement 166
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260. Incorrectly connecting this equipment to a
Warning This product requires
Warning Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 1053
Warning Use of controls, adjustments, or performing procedures other than those specified may result in hazardous radiation exposure. Statement 1057
Pre-installation Instructions
Caution Before attempting any installation, read Chapter 2, “Preparation for Installation.”
To safely and successfully prepare the environment for your Cisco SFS 7000P and SFS 7000D Server Switches, you need to do the following:
•Check the contents of the switch
•Always use an approved ESD-preventative ankle or wrist strap.
•Make sure you have the correct cables and sufficient ventilation.
•Prepare a management workstation, such as a PC running a terminal program, with the cable and adapter required for your specific configuration.
Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide
| ||
|