B-15
CiscouBR924 Software Configuration Guide
OL-0337-05 (8/2002)
AppendixB Using the Cable M onitor Tool
Sample Pages
CPE State Information
This page summarizes how the Cisco uBR924 router has been configured at the MAC (physical) layer.
Figure B-4 shows a typical CPE State Information page.
FigureB-4 CPE State Information Page
The following information is shown in the CPE State Information page:
•Router Name—Shows the hostname assigned to the router.
•IP Address—Shows the IP address assigned to the router’s cable interface.
•Net Mask—Shows the subnet mask for the cable interface.
•MAC State—Indicates the current MAC layer state (during normal operation, this is
“maintenance_state”). The following are the possible MAC layer states; they correspond to the
states shown in the Initialization Information page:
–
wait_for_link_up_state—Wait for Link Up state
–
ds_channel_scanning_state—Downstream Channel Scanning state
–
wait_ucd_state—Wait for UCD state
–
wait_map_state—Wait for MAP state
–
ranging_1_state—Ranging 1 state