Cisco Systems VC-289 Configuring a Prefix to a Gatekeeper Zone List, Command, Purpose, VC-326

Configuring H.323 Gatekeepers and Proxies

H.323 Gatekeeper Configuration Task List

The following is an example of an RRQ notification sent from the gatekeeper to the server when the above trigger condition matches:

REQUEST RRQ

Version-id:1

From:sj.xyz.com

To:Server-123

Notification-Only:

Content-Length:89

c=I:172.18.00.00:1720

r=I:172.20.01.40:16523 a=H:gw3-sj t=voice-gateway

p=1# 2#

Configuring a Prefix to a Gatekeeper Zone List

To add a prefix to a gatekeeper zone list, use the following commands beginning in global configuration mode:

	Command	Purpose
Step 1
	Router(config)# gatekeeper	Enters gatekeeper configuration mode.
Step 2
	Router(config-gk)# zone prefix gatekeeper-name	Adds a prefix to the gatekeeper zone list.
	e164-prefix[blast seq] [gw-priority priority	For an explanation of the keywords and arguments,
	gw-alias [gw-alias, ...]]
		see Step 3 of the configuration task table in the
		“Starting a Gatekeeper” section on page 304.

Note Note that the zone prefix command matches a prefix to a gateway. It does not register the gateway. The gateway must register with the gatekeeper before calls can be completed through that gateway.

Verifying an Added Prefix

To view the prefixes added to the gatekeeper zone list, use the show gatekeeper zone prefix command. To see gatekeeper zone information, use the show gatekeeper zone status command.

Cisco IOS Voice, Video, and Fax Configuration Guide

VC-326