Cisco Systems VC-289 Command, Purpose, “Configuring a Proxy Without ASR” section on, page, VC-344

Configuring H.323 Gatekeepers and Proxies

H.323 Gatekeeper Configuration Task List

	Command	Purpose
Step 9
	Router(config-if)# h323 asr [bandwidth	Enables ASR and specifies the maximum bandwidth
	max-bandwidth]	for a proxy.
		The optional max-bandwidthargument specifies the
		maximum bandwidth on the interface. Value ranges
		are from 1 to 10,000,000 kbps. If you do not specify
		max-bandwidth, this value defaults to the bandwidth
		on the interface. If you specify max-bandwidthas a
		value greater than the interface bandwidth, the
		bandwidth will default to the interface bandwidth.
Step 10
	Router(config-if)# ip address ip-address mask	Sets up the ASR interface network number.
	[secondary]	For an explanation of the keywords and arguments,
		see Step 3 in this configuration task table.
Step 11
	Router(config-if)# exit	Exits interface configuration mode and returns to
		global configuration mode.
Step 12
	Router(config)# interface type number [name-tag]	Enters interface configuration mode on a non-ASR
		interface.
		For an explanation of the keywords and arguments,
		see Step 2 in the configuration task table in the
		“Configuring a Proxy Without ASR” section on
		page 333.
Step 13
	Router(config-if)# ip address ip-address mask	Sets up a non-ASR interface network number.
	[secondary]	For an explanation of the keywords and arguments,
		see Step 3 in this configuration task table.
Step 14
	Router(config-if)# exit	Exits interface configuration mode.
Step 15
	Router(config)# router igrp autonomous-system	Configures Interior Gateway Routing Protocol
		(IGRP) for a non-ASR interface. The
		autonomous-systemargument specifies the
		autonomous system number that identifies the routes
		to the other IGRP routers. It is also used to tag the
		routing information.
Step 16
	Router(config)# network network-number	Includes a non-ASR interface in an IGRP domain.
		The network-numberargument specifies the IP
		address of the network of the directly connected
		networks.
Step 17
	Router(config)# network network-number	Includes a loopback interface in an IGRP domain.
		The network-numberargument specifies the IP
		address of the network of the directly connected
		networks.
Step 18
	Router(config)# router igrp autonomous-system	Configures IGRP for an ASR interface. The
		autonomous-systemargument specifies the
		autonomous system number that identifies the routes
		to the other IGRP routers. It is also used to tag the
		routing information.

Cisco IOS Voice, Video, and Fax Configuration Guide

VC-344