Cisco Systems VC-289 manual Command, Purpose, multipoint point-to-point-Optional, VC-334

Configuring H.323 Gatekeepers and Proxies

H.323 Gatekeeper Configuration Task List

	Command	Purpose
		• :channel-group—Specifies a T1 channel group
			number in the range 0 to 23 defined with the
			channel-groupcontroller configuration
			command. On a dual port card, it is possible to
			run channelized on one port and primary rate on
			the other port.
			Cisco MC3810 specifies the T1/E1 channel
			group number in the range 0 to 23 defined with
			the channel-groupcontroller configuration
			command.
		•	.subinterface-number—Specifies a subinterface
			number in the range of 1 to 4,294,967,293. The
			number that precedes the period (.) must match
			the number to which this subinterface belongs.
		•	multipoint point-to-point—(Optional)
			Specifies a multipoint or point-to-point
			subinterface. There is no default.
Step 3
	Router(config-if)# h323 interface [port-number]	Selects an interface whose IP address will be used by
		the proxy to register with the gatekeeper. The
		port-numberargument specifies the port number on
		which the proxy will listen for incoming call setup
		requests:
		• The port-numberrange is from 1 to 65,356. The
			default port number for the proxy is 11,720 in
			-isx- or -jsx- Cisco IOS images.
		• The default port number for the proxy is 1720 in
			-ix- Cisco IOS images, which do not contain the
			Voice over IP (VoIP) gateway.
Step 4
	Router(config-if)# h323 h323-idh323-id	Configures the proxy name. (More than one name
		may be configured if necessary.)
		The h323-idargument specifies the name of the
		proxy. It is recommended that this be a fully qualified
		e-mail identification (ID), with the domain name
		being the same as that of its gatekeeper.

Cisco IOS Voice, Video, and Fax Configuration Guide

VC-334