Configuring H.323 Gatekeepers and Proxies
H.323 Gatekeeper Configuration Examples
Gatekeeper
Configuring HSRP on the Gatekeeper Example
This sample configuration uses Ethernet 0 as the HSRP interface on both gatekeepers.
On the primary gatekeeper, enter these commands:
configure terminal
!Enter global configuration mode. interface ethernet 0
!enter interface configuration mode for interface ethernet 0. standby 1 ip 172.21.127.55
!Member of standby group 1, sharing virtual address 172.21.127.55. standby 1 preempt
!Claim active role when it has higher priority.
standby 1 timers 5 15
!Hello timer is 5 seconds; hold timer is 15 seconds. standby 1 priority 110
!Priority is 110.
On the backup gatekeeper, enter these commands:
configure terminal interface ethernet 0
standby 1 ip 172.21.127.55 standby 1 preempt standby 1 timers 5 15
The configurations are identical except that gk2 has no standby priority configuration, so it assumes the default priority of
On both gk1 and gk2, set up identical gatekeeper mode configurations, as follows:
configure terminal
!Enter global configuration mode. gatekeeper
!Enter gatekeeper configuration mode.
zone local
!Define local zone using HSRP virtual address as gatekeeper RAS address.
.
.
.
!Various other
no shut
! Bring up the gatekeeper.
configure terminal
!Enter global configuration mode. gatekeeper
!Enter gatekeeper configuration mode.
zone local
!Define local zone using HSRP virtual address as gatekeeper RAS address.
!Note this uses the same gkname and address as on gk1.
.
.
!Various other
! Bring up the gatekeeper.
Cisco IOS Voice, Video, and Fax Configuration Guide