13-18
Software Configuration Guide—Release 12.2(25)SG
OL-7659-03
Chapter13 Understanding and Configuring STP
Configuring STP
This example shows how to verify the configuration:
Switch# show spanning-tree vlan 200 bridge brief
Hello Max Fwd
Vlan Bridge ID Time Age Delay Protocol
---------------- -------------------- ---- ---- ----- --------
VLAN200 49152 0050.3e8d.64c8 7 20 15 ieee
Switch#
Configuring the Maximum Aging Time for a VLAN
Note Exercise care when configuring aging time. In most cases, we recommend that you use the
spanning-tree vlan vlan_ID root primary an d the spanning-tree vlan vlan_ID root secondary
commands to modify the maximum aging time.
To configure the spanning tree maximum aging time for a VLAN, perform this task:
This example shows how to configure the maximum aging time for VLAN 200 to 36 seconds:
Switch# configure terminal
Switch(config)# spanning-tree vlan 200 max-age 36
Switch(config)# end
Switch#
This example shows how to verify the configuration:
Switch# show spanning-tree vlan 200 bridge brief
Hello Max Fwd
Vlan Bridge ID Time Age Delay Protocol
---------------- -------------------- ---- ---- ----- --------
VLAN200 49152 0050.3e8d.64c8 2 36 15 ieee
Switch#
Configuring the Forward-Delay Time for a VLAN
Note Exercise care when configuring forward-delay time. In most cases, we recommend that you use the
spanning-tree vlan vlan_ID root primary an d the spanning-tree vlan vlan_ID root secondary
commands to modify the forward delay time.
Command Purpose
Step1 Switch(config)# [no] spanning-tree vlan
vlan_ID
max-age
max_age
Configures the maximum aging time of a VLAN. The
max_age value can be from 6 to 40 seconds.
You can use the no keyword to restore the defaults.
Step2 Switch(config)# end Exits configuration mode.
Step3 Switch# show spanning-tree vlan
vlan_ID
bridge
[brief]
Verifies the configuration.