Cisco Systems WSC4500X16SFP 27-37, This example shows how to create a flow-based class map associated with a desti nation address:

27-37
Software Configuration Guide—Release 12.2(25)SG
OL-7659-03
Chapter27 Configuring Quality of Service
Configuring QoS
Switch# show class-map c1
Class Map match-all c1 (id 2)
Match flow ip source-address
Example 2
This example shows how to create a flow-based class map associated with a desti nation address:
Switch(config)# class-map match-all c1
Switch(config-cmap)# match flow ip destination-address
Switch(config-cmap)# end
Switch#
Switch# show class-map c1
Class Map match-all c1 (id 2)
Match flow ip destination-address
Example 3
Assume there are two active flows on the Fast Ethernet interface 6/1 with source addresses
192.168.10.20 and 192.168.10.21. The following example shows how to maintain each flow to 1 Mbps
with an allowed burst value of 9000 bytes:
Switch# conf t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# class-map c1
Switch(config-cmap)# match flow ip source-address
Switch(config-cmap)# exit
Switch(config)# policy-map p1
Switch(config-pmap)# class c1
Switch(config-pmap-c)# police 1000000 9000
Switch(config-pmap-c)# exit
Switch(config-pmap)# exit
Switch(config)# interface fa6/1
Switch(config-if)# service-policy input p1
Switch(config-if)# end
Switch# write memory
Switch# show policy-map interface
FastEthernet6/1
Service-policy input: p1
Class-map: c1 (match-all)
15432182 packets
Match: flow ip source-address
police: Per-interface
Conform: 64995654 bytes Exceed: 2376965424 bytes
Class-map: class-default (match-any)
0 packets
Match: any
0 packets