37-18
Software Configuration Guide—Release 12.2(25)SG
OL-7659-03
Chapter37 Configuring SPAN and RSPAN
Configuring RSPAN
This example shows how to clear any existing RSPAN configuration for session 1, configure RSPAN
session 1 to monitor multiple source interfaces, and configure the destination RSPAN VLAN.
Switch(config)# no monitor session 1
Switch(config)# monitor session 1 source interface fastEthernet3/10 tx
Switch(config)# monitor session 1 source interface fastEthernet3/2 rx
Switch(config)# monitor session 1 source interface fastEthernet3/3 rx
Switch(config)# monitor session 1 source interface port-channel 102 rx
Switch(config)# monitor session 1 destination remote vlan 901
Switch(config)# end
Creating an RSPAN Destination Session
To create an RSPAN destination session and to specify the source RSPAN VLAN and the destination
port, perform this task:
Step7 Switch(config)# monitor session
session_number
destination remote vlan
vlan-ID
Specifies the RSPAN session and the destination remote VLAN.
For session_number, specifies the session number identified with this
RSPAN session (1 through 6).
For vlan-ID, specifies the RSPAN VLAN to carry the monitored
traffic to the destination port.
Step8 Switch(config)# end Returns to privileged EXEC mode.
Step9 Switch# show monitor [session
session_number
]
Verifies your entries.
Step10 Switch# copy running-config
startup-config
(Optional) Saves your entries in the configuration file.
Command Purpose
Command Purpose
Step1 Switch# configure terminal Enters global configuration mode.
Step2 Switch(config)# monitor session
session_number
source
remote vlan
vlan-ID
Specifies the RSPAN session and the source RSPAN VLAN.
For session_number, specifies the session number identified with this
RSPAN session (1 through 6).
For vlan-ID, specifies the source RSPAN VLAN to monitor.