Basic Operations
Adjusting the CLOCK
Note:
•This setting is disabled when the Navigation system is connected. The clock is automatically adjusted using the CT (clock time) data in the GPS data.
1.Press the [ADJ] button, then touch the [CLOCK] key.
2.Touch the [{] and [}] keys under the Hour, Minute and a.m./p.m. box to adjust the time, then touch the [SET] key (The factory default setting is “1:00 a.m.”).
* The time is displayed in
Setting the anti-theft function (CATS)
“CATS” is the acronym of “Clarion
When you set a PIN code (called as “Personal Code”), a theft is prevented by disabling the operation of the unit at the theft.
In addition, set the BLINK LED function in the GENERAL menu to [ON] to improve the effect of the CATS function (see page 25).
Setting your Personal Code
1.Press the [ADJ] button, then touch the [GENERAL] key.
2.Keep pressing the [MENU] button more than 2 seconds.
The SET PERSONAL CODE screen appears.
* When a Personal Code is already set, the ERASE PERSONAL CODE screen will appear. Retry this operation after erasing the old Personal Code.
3.Enter your desired
* Touch the [CLR] key when you make a mistake in entering.
Note:
•Write down your Personal Code in case you forget it.
4.Enter the same Personal Code again for confirmation, then touch and hold the [ENT] key for more than 2 seconds.
The entered Personal Code will be set, and it will return to the previous screen.
Erasing the Personal Code
1.Press the [ADJ] button, then touch the [GENERAL] key.
2.Keep pressing the [MENU] button more than 2 seconds.
The ERASE PERSONAL CODE screen appears.
3.Enter the Personal Code currently set by touching the [0] to [9] keys, then touch and hold the [ENT] key for more than 2 seconds. The message “CODE ERASED” appears, and it will return to the previous screen.
When the ENTER PERSONAL CODE screen appears
The ENTER PERSONAL CODE screen will be displayed when turning the ACC power on after performing the following operations:
•The car battery was replaced.
•The backup power was cut off.
•The Reset button was pressed.
Note:
•If you have lost your Personal Code, please contact Clarion customer service at
1.Enter your Personal Code currently set.
2.When the correct Personal Code is entered, the unit will restart from the initial startup screen.
Note:
•When you enter a wrong Personal Code, the message “CODE INCORRECT” is displayed and the Personal Code entry is prohibited for a while. This prohibited time is changed according to the number of times of wrong code entry as follows:
•1 to 6 times: 15 seconds
•7 times or more: 15 minutes
English Owner’s manual
MAX675VDII 27
