Appendices ~ Appendix E: Serial Commands
MASTER
This command selects or returns the current mode of the AP400 from the serial port.
[DEVICE] MASTER <X>
Explanation
<X>
X=1 | Parameter to designate the AP400 as master- |
| single |
X=3 | Parameter to designate the AP400 as slave |
X=4 | Parameter to designate the AP400 as master- |
| linked |
X=Null | Parameter to return the current mode |
Return Values
The command will return the updated condition of the mixer in the same format as the command.
MDMODE
This command enables or disables the modem mode for the AP400. When the modem mode is enabled, the modem initialization string is sent out the serial port and the serial port then requires a password before a command is processed. Note: The default password is a carriage return (enter). If the password is forgotten, it can be cleared back to a carriage return via the front panel.
[DEVICE] MDMODE <X>
Explanation
<X>
X=0 | Sets modem mode to OFF |
X=1 | Sets modem mode to ON |
Return Values
The command will return the updated condition (1=On, 0=Off) of the pin in the same format as the command.
After five minutes of serial inactivity, the password will be requested to continue serial activity. For immediate password protection, see BYE command (page 48).
55
MEQ
This command changes or reports back the state of the equalizer adjustment for a microphone input.
[DEVICE] MEQ <CH> <BAND> <X>
Explanation
<CH>
CH= | Parameter to apply to the |
| specified microphone channel |
CH= * | Parameter to apply command to |
| all microphone channels |
<BAND> |
|
BAND=H, M, L | Parameter to select which band |
| is modified |
<X> |
|
X= | Parameter to set level of the |
| band |
X=Null | Parameter to return the current |
| level |
Return Values
The command will return the updated condition of the equalizer in the same format as the command.
