LUBRICATION
Lubricate the following parts every three months to insure smooth operation and reduce wear.
DISASSEMBLY OF SWITCH ASSEMBLY
Front | Back |
Cover | Cover |
Grease
Nipples
Side View of 18" Console
Adjusting
Screw
Worm
Screw and
Tilt
Gear
Cross
Bar
MIXER BRIDGE HOUSING
There are two grease nipples on the mixer bridge swivel housing which are accessed by removing the front and back covers on the 18" console.
TRUNNION
HOUSING, WORM SCREW AND TILT GEAR
These parts are accessed through the front cover on the 18" console.
Fig. 1 |
|
| Contactor |
| cartridges |
Fig. 2 |
|
Fig. 3 |
|
Fig. 4 | Cartridge |
| |
Locking | mounting |
ring | block |
| |
Rotary switch | |
1.Place slotted screwdriver between contactor cartridge and cartridge mounting block as shown in Fig.1.
2.Twist screwdriver to free cartridge.
3.Place screwdriver under tab in the back of the cartridge mounting block as shown in Fig. 3.
4.Twist screwdriver to remove block from the rotary switch.
3.Unscrew locking ring to remove rotary switch.
Trunnion and Tilt Mechanism Drawing
Switch Assembly
Apply grease to gear teeth. Check for excessive play and adjust with adjusting screw located on top of cross bar.
Trunnion Housing |
Grease Nipple |
Kettle Trunnion Drawing
KETTLE
TRUNNIONS
Accessed via the top covers on the 10" and 18" consoles. Each has two grease nipples.
35
