Cognitive Solutions B780, A776 Select sensors to stop printing, Enable or disable panel button

40 Chapter 5: Programming commands

Select sensors to stop printing

ASCII		ESC c 4 n
Hexadecimal		1B 63 34 n
Decimal		27 99 52 n
Value of n:		Sensor status
Default:		0
Bit of n
Bit	Function
0,1	Stop receipt on receipt low
4	Stop slip if trailing edge uncovered
5	Stop slip if leading edge uncover

7Stop validation print if trailing edge uncovered (B780 only)

Determines which sensor stops printing on the respective station. The command does not affect the paper out status on the receipt station, which will automatically stop the printer when the paper is depleted.

Enable or disable panel button

ASCII	ESC c 5 n
Hexadecimal	1B 63 35 n
Decimal	27 99 53 n
Value of n:	0	= Enable
	1	= Disable
Default:	0	(Enable)

Enables or disables the paper feed button. If the last bit

is 0, the paper feed button is enabled. If the last bit is 1, the paper feed button is disabled.

Related information

Functions that require the paper feed button (except for the execute macro [1D 5E r t m] command) cannot be used when it has been disabled with this command.

Set slip paper waiting time

ASCII	ESC f m n
Hexadecimal	1B 66 m n
Decimal	27 102 m n
Value of m:	Not used
Value of n:	Tenths of seconds

The time that the printer waits for a slip to be inserted is set using the configuration menu. The default is forever, but it can be set to 1, 3, or 5 minutes.

The value “n” sets the time (n x 0.1 seconds) that the printer waits to close the platen and start printing after the slip has been inserted. The printer reads that a slip is inserted when the leading edge and trailing edge sensors are covered. The slip-in light is lit (green) when both sensors are covered.

If a slip is not inserted in the time specified, the receipt station is selected for the next function.

A776 (B780) Programming Guide A776-PG00001 C 12/09