Compaq GS80, GS160, GS320 manual Dialing

➊Enables remote access to the SCM modem port.

➋Sets the password (in the example, “wffirmare”) that is prompted for at the beginning of a modem session. The string cannot exceed 14 characters and is not case sensitive. For security, the password is not echoed on the screen. When prompted for verification, type the password again.

➌Sets the modem initialization string. The string is limited to 31 characters and can be modified depending on the type of modem used.

The SCM automatically configures the modem's flow control according to the setting of the SRM com1_flow environment variable. The SCM also enables the modem carrier detect feature to monitor the modem connectivity.

After the initialization string is set, it is copied to the SCM’s EEPROM to allow the SCM to reinitialize the modem in the case of a system power cycle.

➍The init command is entered to initialize the modem.

➎At this point, the modem is configured for remote dial-in.

Dialing In

Once the remote session is connected, the password must be entered to access the SCM CLI. The following example shows the screen output when a modem connection is established.

atdt915085551212 CONNECT 9600

Password: **********

Access granted

Modem escape sequence verified

SCM_E0>

1.At the SCM_E0> prompt, enter SCM CLI commands to monitor and control the system. Use the show status command to check the current manage- ment settings and the channel the modem connection is currently using.

2.When you have finished a modem session, enter the hangup command to cleanly terminate the session and disconnect from the server.

Using the System Control Manager 8-25