Compaq GS160, GS80, GS320 manual Alert Condition

➊Sets the string to be used by the SCM to dial out when an alert condition occurs. The dial string must include the appropriate modem commands to dial the number.

➋Sets the alert string that is transmitted through the modem when an alert condition is detected. Set the alert string to the phone number of the modem connected to the remote system. The alert string is appended after the dial string, and the combined string is sent to the modem.

➌Alert dial-out is enabled.

➍Issue the test alert command to test the alert dial-out settings.

➎Now issue the show status command to verify settings. Note that the alert pending value is YES (➏), indicating the test alert was successful.

➐Once the dial-out settings are verified, the pending alert should be cleared by entering the clear alert command.

Paging services vary, so you need to become familiar with the options provided by the paging service you will be using. The SCM supports only numeric mes- sages.

NOTE: If you do not want dial-out paging enabled at this time, enter the disable alert command after you have tested the alert dial-out function. Alerts continue to be logged, but no paging occurs.

Alert Conditions Reported to a Remote Operator

Alert Condition Detected By:

PSM (power system manager)

HPM (H-switch power manager)

PBM (PCI backplane manager)

User

Alert Condition

Blower failure Power failure Overtemperature condition

Overtemperature condition Power failure

System clock failure

Fan failure Overtemperature condition Power supply failure

User-initiated alert

Using the System Control Manager 8-27