Compaq TC1000 manual Removing the System Board Screws

Removal and Replacement Procedures

13.Release the ZIF connector 1 to which the LED board cable is attached and disconnect the LED board cable 2 from the system board (Figure 5-24).

14.Remove the four PM2.0 × 5.0 screws that secure the system board to the base enclosure. The screws are located in the following locations:

❏Next to the pen holder spring clip 3

❏Directly behind the USB connectors 4

❏Directly behind the external monitor connector 5

❏Left side of the heat sink grille 6

Figure 5-24. Removing the System Board Screws

Maintenance and Service Guide 5–29