Compaq TC1000 manual Removing the Docking Stand and Pivot Arm

Removal and Replacement Procedures

✎Make sure the docking stand and pivot arm are supported before removing the following screws. The docking stand and pivot arm can fall if not supported.

7.Remove the following screws:

❏Two PM2.5 × 5.0 screws 1 that secure the cable bracket to the bottom case (Figure 5-33)

❏One PM2.5 × 12.0 screw 2 that secures the pivot arm hinge to the bottom case

❏Three PM2.5 × 6.0 screws 3 that secure the pivot arm hinge to the bottom case

8.Remove the docking stand and pivot arm 4.

Figure 5-33. Removing the Docking Stand and Pivot Arm

5–40 Maintenance and Service Guide