Compaq TC1000 manual Removing the Fan and Heat Sink

Removal and Replacement Procedures

7.Turn the system board bottom side up with the heat sink grille facing you.

8.Remove the mylar system board shield 1 (Figure 5-27).

9.Remove the three PM2.0 × 5.0 screws 2 that secure the fan and heat sink to the system board.

10.Lift the system board straight up 3. The fan and heat sink 4 will remain resting on the work surface.

Figure 5-27. Removing the Fan and Heat Sink

Reverse the preceding procedures to install the EMI shield, fan, and heat sink.

Maintenance and Service Guide 5–33