Concord Camera DV2020 manual E64, Properties Hardware Device, Manager Imaging Device , then

The downloaded	The Div X player from	Install the Div X player from the
video clips cannot be	the supplied CD-	supplied CD-ROM. (page 51)
played back.	ROM is not installed
	on your computer.
I cannot use ArcSoft	Connection failure	Check to make sure all cable
VideoImpression to		connections are properly and securely
capture live video		plugged in.
clips by showing
message “ cannot
connect to device”.
	The imaging device	1. Install the camera drivers from the
	for DV2020 camera is	supplied CD-ROM onto your
	not installed in your	computer. (page 51)
	computer.	2. Connect the camera to the
		computer.
		3. Set the Mode Dial to the (	)
		position.
		4. Power on the camera.
		You may check whether the
		imaging device has been installed
		on your comuter successfully or
		not by going to My Computer –
		Properties – Hardware – Device
		Manager – Imaging Device, then
		click Imaging Device to check
		whether DV2020 is shown under
		it. If not, or the itme of DV2020 is
		marked with the exclamation mark,
		re-install the camera drivers from
		the supplied CD-ROM, then do the
		steps from 2 to 4 listed above to
		install the imaging device onto your
		computer.

E64