Connect Tech CTIM-00044 user manual Serial Mode smode Async MonoSync BiSync Trans-BiSync

Connect Tech Blue Heat/Net Sync User Manual

Serial Mode (smode)	Async	MonoSync	BiSync	Trans-BiSync	HDLC
BHN_PortSettings
sync_addr.rx0		Required	Required	Required	Required
sync_addr.rx1			Required	Required	Optional
sync_addr.rx_len		Required	Required	Required
sync_addr.strip_sync		Optional	Optional	Optional
dbits.t/rx	Required	Required	Required	Required	Required
tx_frac_stop	Required
parity.t/rx	Required
crc.tx_type		Required	Required	Required	Required
crc.tx_start		Optional [6]	Optional [6]	Optional [6]	Optional [6]
crc.tx_mode		Optional [6]	Optional [6]	Optional [6]	Optional [6]
crc.rx_type		Optional [6]	Optional [6]	Optional [6]	Optional [6]
crc.tx_start		Optional [6]	Optional [6]	Optional [6]	Optional [6]
tx_trig_gate	Required	Required
rx_gate	Required	Required

Required [1]: Must be NRZ or NRZ_INV

Optional [1]: Needed if a clocking source feeds either of the Baud Rate Generators. If the Receiver or Transmitter are clocked directly from certain Line Interface signals (RxC or TxC setup as inputs) and those Interface signals are setup as outputs, then the indicated parameters are required.

Optional [2]: Required only when the DPLL is part of the clocking tree setup.

Optional [3]: Required only when either Counter (CTR-0 or CTR-1) is directly clocking the Receiver, Transmitter, RxC or TxC signals.

Optional [4]: Only required when the clk_tree.A setting is CLK_DPLL (which is generally only used with Synchronous modes).

Optional [5]: Only required when the clk_tree.A or clk_tree.C setting selects a Baud Rate generator.

Optional [6]: Only required if CRC is enabled.

60 Revision 0.03