Connect Tech Blue Heat/Net Sync User Manual

Hardware Installation

Connecting the Blue Heat/Net Sync to Your Network:

Before you begin, take a minute to ensure that your package includes the required components for your Blue Heat/Net Sync:

One Blue Heat/Net Sync unit

One power supply

One CD containing software and documentation

One Phoenix contact screw terminal plug PN: 1847055

One RJ-45 cable (optional)

If any of these components is missing, contact Connect Tech or your reseller.

Ethernet LEDs

The front panel of the Blue Heat/Net Sync features Ethernet and serial port LEDs to monitor activity.

Power: When this LED is on, the Blue Heat/Net Sync is receiving power.

CPU: Once the uClinux firmware is booted and running correctly, this LED lights up.

10/100: This LED represents the line rate at which the Blue Heat/Net Sync is connected to your network.

LED on = a 100 megabit connection.

LED off = a 10 megabit connection.

(The Blue Heat/Net Sync automatically detects the line rate of your network).

L/A: This light illuminates when the connection to your network or computer is achieved.

A blinking light indicates that Transmit (Tx) or Receive (Rx) activity is detected on the Ethernet cable.

FD: Indicates that your network is running in full duplex or half duplex mode: ON = full duplex, OFF = half duplex

Figure 1: LED Locations on Blue Heat/Net Sync

Revision 0.03

11

Page 11
Image 11
Connect Tech CTIM-00044 user manual Connecting the Blue Heat/Net Sync to Your Network, Ethernet LEDs