Philips V200 manual Connecting AC Power Cord, Grounded AC power outlet

Chapter 5

Setup

NOTE:	All volumes entered into the ventilator are assumed to be BTPS (Body
	Temperature atmospheric Pressure Saturated (with H2O)) volumes
	unless otherwise noted. All volumes reported by the ventilator are
	reported as BTPS volumes. All pressures are assumed to be relative to
	atmospheric pressure unless otherwise noted.
NOTE:	The Air Inlet Filter houses a reusable foam filter that should be
	periodically cleaned. Refer to Chapter 10, “Care and
	Maintenance”, for more information on filter changes.

Connecting AC Power

Cord

	2
	3
	1
	Circuit Breaker
	Cover not shown.
	Figure 5-2: AC Power Cord Retaining Bracket
WARNING:	To avoid electrical shock hazard, connect the ventilator to a properly
	grounded AC power outlet.
CAUTION:	Before connecting the ventilator to the AC power source, ensure that the
	total electrical load does not exceed the ampere rating of the AC branch
	circuit, especially when using the ventilator with other electrical
	equipment. An AC branch circuit includes all outlets serviced by a
	single circuit breaker. If the maximum current drain through a branch
	circuit exceeds the circuit breaker’s rating, the branch circuit will open,
	causing the ventilator to lose power. For further information, consult a
	service technician or a trained biomedical technician.
CAUTION:	The ventilator is shipped with a power cord that complies with electrical
	safety standards. Do not use substitute power cords unless specifically
	instructed to do so by an authorized distributor or qualified personnel.
	Do not modify the power cord or connect it with electrical extension
	cords or outlet adapters.

REF 1057983 A Respironics V200 Ventilator Operator’s Manual 5-3