Unpacking and Checking Contents
Tools Needed
Combination Square must be true. Check it's accuracy as shown below.
Utility Knife
Phillips Screwdriver | Tape Rule |
Draw light line on board along edge
I i
LI
Select the straight edge of 314" thick board. This edge must be perfectly straight.
straight edge are used to
align the saw, They must NOTE: The square and be accurate if the saw is
to be aligned properly,
Medium Screwdriver
Small Screwdriver
\
Should be no gap or overlap here when square is flipped over in dotted position,
Combination | Wrenches |
| _., | Combination | |
3!8 ino,7116 In,, | 112 Ino, 9/16 | In. | |||
|
| ||||
|
|
|
| Square | |
|
|
|
| ,_',',i- '.;:: '. 'I._,t | |
Hex "L" Wrenches |
|
|
| ||
3/16 In., 1/8 In, |
| Framing Square |
| ||
Unpacking
1 Separate saw and all parts from packing materials and check each one with the illustration and the "List of Loose Parts" to make certain all items are accounted for, before discarding any packing material
WARNING: If any parts are missing, do not attempt to assemble the table saw, plug in the power cord or turn the switch on until the missing parts are obtained and are installed correctly.
WARNING: The saw is heavy° To avoid back injury, get help to lift the saw. Hold the saw close to your body. Bend your knees so you can lift with your legs, not your back.
WARNING: For your own safety, never connect plug to power source outlet until all assembly steps are complete, and you have read and under- stand the safety and operating instructions.
NOTE: Before beginning assembly:
o Check that all parts are included If you are missing any part, do not assemble the saw Contact your Sears Ser- vice Center to get the missing part
o Sometimes small parts can get lost in packaging mate* riat Do not throw away any packaging until saw is put together Check packaging for missing parts before contacting Sears
o A complete parts list (Repair Parts) is at the end of the manual Use this list to identify the part number of the missing part
10
