Craftsman 113.29921 owner manual Blade Elevation, Tilt and Elevation Mechanism, Tilt Screw, Screws

Adjustments (continued)

Blade Elevation

When the eIevation handwheel is turned clockwise, until it stops, the blade must not be more that 2-5/8 inches above the table If the b}ade extends more than 2-5/8 inches, the motor could interfere with the underside of the table causing misalignment,

With the blade extending 2-5/8 inches above the table, the stop collar and spacer must be against the elevation screw pivot nut If the blade extends more that 2-5/8 inches, loosen two screws in stop collar, and readjust it,

Tilt and Elevation Mechanism

The handwheels should turn freely without binding, The turning action can be adjusted by tighten{ng or loosening the screws in the bearing retainer Both handwheels must be removed to reach the adjusting screws

f

Tilt Screw

Tilt

Handwheel

Step

Elevation

Spacer

!

I

"Elevation Screw

Pivot Nut

1

Tilt Screw

Pivot Nut

Elevation

NOTE: When adjusting the screws on the tilt bearing retainer, ho_d the nut inside using a 3/8" wrench, The screws for the elevation bearing retainer can be reached with a small screwdriver through the curved slot on the front of the saw

_'_ _-_Handwheel

Adjust	Thes_	!	,_'_-,,_J_
Two	Screws	_	_OJ F[_

Adjust These

Two Screws

42