5.,If blade is not square to table, the 90° limit stop must be adjusted,

I CAUTION"protect yourCoverhand.blade with piece of cardboard to !I

A Using a small size screwdriver, reach underneath saw and loosen both set screws in 90° stop collar,

NOTE: If you can't reach the set screws turn the tilt handwheel slightly

B Rotate the stop collar moving it away from pivot nuL CTilt blade right or left, checking with your square until

blade is square to table.

D Rotate stop collar toward pivot nut until it touches the pivot nut., Tighten the set screws_

E Check pointer, if it does not point to the "0" mark on the bevel scale bend pointer to read "0"

6,,Tilt blade to left as far as it will go it will stop when the pivot nut is against the 45 ° stop collar

7, PIace an accurate square against blade, Make sure square is not touching the tip of one of the saw teeth

Blade Covered

With Piece of

8, It blade is not 45 ° to table, the 45 ° stop collar must be adjusted

A Remove elevation handwheel

BUsing a small size screwdriver, reach through curved slot in front trim panel and loosen both set- screws in 45° stop collar

NOTE: If you can't reach the setscrews, turn the tilt handwheel slightly

C Rotate the stop collar moving it in or out and tilt blade right or left, checking with your square, until blade is 45 ° to tabte

D Tighten the setscrews

NOTE; If you can't reach the setscrews, turn the tilt handwheel slightly

E Reinstall elevation handwhee!

45°

Stop

Setscrews

41

Page 41
Image 41
Craftsman 113.29921 owner manual With Piece