Motor Specifications

and Electrical Requirements

1

_ower Supply and Motor Specifications

WARNING: To avoid electrical hazards, fire haz- ards or damage to the tool, use proper circuit pro- tection. Your tool is wired at the factory for operation using the voltage shown. Connect toot to a power line with the appropriate voltage and a 15-amp branch circuit. Use a 15-amp time delay type fuse or circuit breaker. To avoid shock or fire, if power cord is worn or cut, or damaged in any way, have it replaced immediately.

i ,,u..............

General Electrical Connections

DANGER: To avoid electrocution:

1.Use only identical replacement parts when ser- vicing, Servicing should be performed by a

qualified service technician.

2, Do not use in rain or where floor is wet.

This tool is intended for indoor residential use

.........only.

The A-C motor used in this tool is a relay start, non-revers- ible type, having the following specifications:

Rated H P

1

Voltage110-120

Amperes

1t 5

Hertz (Cycles) 60

PhaseSingle

RPM3450

Rotation of Shaft Counterclockwise

7 WARNING: Do not permit fingers to touch the ter-

minals of plug when installing or removing the plug to or from the outlet.

110-120Volt, 60 Hz. Tool Information

NOTE: The plug supplied on your toof may not fit into the outtet you are planning to use Your local electrical code

may require slightly different power cord plug connec- tions if these differences exist refer to and make the

proper adjustments per your local code before your tool is plugged in and turned on

In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock This toot is equipped with an electric cord having an equipment-grounding con- ductor and a grounding plug, as shown,, The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local codes and ordinances

Do not modify the plug provided, If it will not fit the outlet, have the proper outlet installed by a qualified electrician A temporary adapter may be used to connect this plug to a 2-prong outlet as shown if a properly grounded three prong outlet is not available,. This temporary adapter should be used only until a properly grounded three prong outlet can be installed by a qualified electrician The green colored rigid ear',lug or the like, extending from the adapter must be connected to a permanent ground such as a properly grounded outfet box

Improper connection of the equipment-grounding con- ductor can result in a risk of electric shock The conduc- tor with insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conductor If repair or replacement of the electric cord or plug is necessary, do not connect the equipment-ground- ing conductor to a live terminal

If the grounding instructions are not completely under- stood, or if you are in doubt as to whether the tool is prop- erly grounded check with a qualified electrician or service )ersonnel.

WARNING: If not properly grounded, this tool can cause an electrical shock, particularly when used in damp locations, in proximity to plumbing, or out of doors_ If an electrical shock occurs there is the potential of a secondary hazard, such as your hands contacting the sawblade.

Properly

 

3-Prong Plug

 

 

Grounded

 

 

3-Prong Outlet

 

 

\ J

 

 

In

111 G!ounding

 

 

Prong

 

 

Make sure this

Grounding Lug

_

Is Connected

 

to a Known Ground

2-Prong Outlet

NOTE: The adapter illustrated is for use only if you already have a properly grounded 2-prong outlet

7

Page 7
Image 7
Craftsman 113.29921 Motor Specifications, 110-120Volt, 60 Hz. Tool Information, Properly Prong Plug Grounded Prong Outlet