Cybex 445T Treadmill Owner’s Manual
11.Run the treadmill through its full % grade range. Press the Incline 
key until the treadmill reaches its highest grade (15%). Then press the Incline 
key until the treadmill is back to 0% grade. Ensure the power cord is not being pinched under the front of the treadmill.
12.Press Stop twice to stop the running belt, end the workout review, and return the display to Dormant Mode.
Setting Operation Options
1.While in Dormant Mode enter Test Mode by holding down the Pause/Stop key for five seconds. The display will read “445T”.
NOTE: After changing any value, you must press Enter to save that value. When you press enter the display will read “updt” (updated) to confirm your selection.
2. Press the Time key to set options, change values with and keys and press Enter to save your selection. Each time you press Time the next set of data is displayed in the following order:
Unit — Choices are “Eng” or “Euro” measurements. English is the default.
Line — This is the frequency of the power line that supplies power to your treadmill. The default setting is 50 Hz for metric consoles and 60 Hz for English consoles. NOTE: If you have an English console and a 50 Hz power line frequency, then you must change the default setting from 60 Hz to 50 Hz for the proper elevation frequency.
Scan — This turns on or off the data readout scan (unless a specific data key is pressed during a workout). Default is on.
Def — This is the default time for time based programs if a user doesn’t
Max — This is the maximum amount of time the treadmill can run per use. You can limit the users time or choose “none” for unlimited time. Choices are between none and 120 minutes; default is 60. NOTE: If the Max time is limited too much it may be difficult for the user to reach their goals. For example, a user may not be able to burn 300 calories if you limit their Max time to 20 minutes.
Idle (or Workout Review/Pause Time): — This is how long the treadmill retains and displays your current workout data during a pause in the workout or after a workout. Choices include: 20 seconds; 30 seconds, 40 seconds; 1 minute and 5 minutes; default is 20 seconds.
SPD — This is the maximum speed the treadmill will run. Choices are between 1 and 11 MPH (1.6 to 17.6 kph).
Setup
and
Assembly
Page
