Cybex International CX-445T manual Ensure all User and Facility safety precautions are observed

Cybex 445T Treadmill Owner’s Manual

•Use a dedicated line when operating the treadmill. NOTE: A dedicated line requires one circuit breaker per unit.

•Connect the treadmill to a properly grounded outlet only.

•DO NOT operate electrically powered treadmills in damp or wet locations.

•Keep the running belt clean and dry at all times.

•DO NOT leave the treadmill unattended when plugged in and running. NOTE: Before leaving the treadmill unattended, always wait until the treadmill comes to a complete stop and is level. Then, turn all controls to the STOP or OFF position and remove the plug from the outlet. Remove the e-stop key from the treadmill.

•Immobilize the treadmill (when not in use) by removing the e-stop key.

•Inspect the treadmill for worn or loose components before each use. Do not use until worn or damaged parts are replaced.

•Maintain and replace worn parts regularly. Refer to “Preventive Maintenance” section of Owner’s Manual.

•DO NOT operate the treadmill if: (1) the cord is damaged; (2) the treadmill is not working properly or (3) if the treadmill has been dropped or damaged. Seek service from a qualified technician.

•DO NOT place the cord near heated surfaces or sharp edges.

•DO NOT use the treadmill outdoors.

•DO NOT operate the treadmill around or where aerosol (spray) or where oxygen products are being used.

•Read and understand the Owner’s Manual completely before using the treadmill.

•Ensure all users wear proper footwear on or around all Cybex equipment.

•Set up and operate the treadmill on a solid, level surface. Do not operate in recessed areas or on plush carpet.

•Provide the following clearances: 19.7 inches (0.5 m) at each side, 39 inches (1.0 m) at the back and enough room for safe access and passage at the front of the treadmill. Be sure your treadmill is clear of walls, equipment and other hard surfaces.

•DO NOT attempt repairs, electrical or mechanical. Seek qualified repair personnel when servicing. If you live in the USA, contact Cybex Customer Service at 800-766-3211. If you live outside the USA, contact Cybex Customer Service at 508-533-4300.

•Use Cybex factory parts when replacing parts on the treadmill.

•DO NOT modify the treadmill in any way.

•DO NOT use attachments unless recommended for the treadmill by Cybex.

• Ensure all User and Facility safety precautions are observed.	Safety
	Page 1-3