Cybex International CX-445T manual Safety Sentry, Control During Operation

Cybex 445T Treadmill Owner’s Manual

Press Pause/Stop a second time to interrupt workout data from cycling and to change the display to Dormant Mode.

The function of the immobilization method: The purpose of immobilizing the treadmill is to prevent unauthorized use. This can be accomplished by removing the e-stop key from the console, unclipping it from the cord and putting it in a non-accessible place. See Figure 2.

The emergency dismount: Follow the steps listed below

if you experience pain, feel faint or need to stop your Figure 2 treadmill in an emergency situation:

1.Grip handrails for support.

2.Step onto the top steps.

3. Pull the e-stop key off the console.

The function of the emergency stop: The e-stop key functions as the emergency stop. In an emergency situation, remove the e-stop key from the console and the treadmill will come to a stop. See Figure 3.

Safety Sentry

If you step off your treadmill during a workout, it may detect that you are not there. After the pre-selected waiting period “run?” will appear in the center window for a few seconds then Safety Sentry™ will stop the belt. If you press Quick Start within the time selected you can resume your workout. NOTE: If you are less than 100 lbs. and you are not using Polar the treadmill may not detect you are there and cause the treadmill to come to a stop. Safety Sentry is disabled above 11% grade. It can also be disabled by setting SAFE time to “none”. If changes in elevation or speed occur while you are not there (such as during a programmed workout) Safety Sentry resets its waiting period.

Control During Operation

Control keys on the display are usable during operation and may be pressed at any time to make adjustments in speed, elevation or data readouts.

Changing Speed — Press the Speed + — keys to change the speed in increments of 0.1 mph or 0.10 kph. Minimum to maximum speed is from 0.5 - 11.0 mph (0.8 - 17.6 kph).

Changing Incline — Press the Incline keys to change the elevation in increments of 1%. Elevation ranges from 0 to 15%. Press either arrow key once to see the current incline setting, press multiple times to change incline setting. NOTE: Elevation is defined as the ratio of rise or fall over run of the treadmill deck.

Operation Page 3-5