Cybex 710T Treadmill Owner’s Manual
| Screws (2) | Screws |
|
| |
End | Side |
|
Rails |
| |
Caps |
|
|
| Screws (2) | Motor |
| Cover |
Figure 2
excessively worn the belt needs to be replaced.
B.Run your hand under the belt on the top of the deck surface. If you feel excessive ridges or cracks, or if the deck feels grooved yet highly polished, the deck should be flipped so that an unused surface faces the top. If the deck is worn on both sides it should be replaced. In time, a worn belt and deck can cause high current draw and ultimately, motor failure. For instructions on replacing the belt and deck, see Running Belt and Deck in the the Service chapter.
4.Clean under the belt.
A.To minimize the effect of friction between the deck and the running belt, Cybex recommends cleaning the underside of the running belt and the top of the running deck surface by wiping them with a clean, dry towel. This cleaning should be done each time you check the belt and deck condition to prevent premature wear of the deck, running belt and the drive motor system. See the Service Schedule in this chapter.
5.Replace the side rails and motor cover.
A.After completing the inspection and cleaning of the deck surface, snap the side rails back down into their original position.
B.Using a 3/16” Allen wrench, attach the two button head screws on the sides of each side rail. See Figure 2.
C.Lower the motor cover in place and tighten the two Phillips screws. See Figure 2.
4 Preventive Maintenance
Regular Maintenance
Activities . . . . . . . . . . . . . .
Cleaning Your Treadmill . . . .
Running Belt Maintenance .
Other Preventive
Maintenance . . . . . . . . . . .
Service Schedule . . . . . . . . .
Log Sheet . . . . . . . . . . . . . . .
Page
