Cybex 710T Treadmill Owner’s Manual
same bolt. Once the running belt has been adjusted closer to the center of the treadmill use about 1/4 of a turn until the belt has been stabilized.
B.After the belt has been centered, check the belt tension again. Make sure the running belt tension is tight enough so that the belt does not slip or hesitate when stepped on. Walk on the treadmill at
NOTE: The springs may eventually compress slightly. If they compress the silver washers may no longer be flush with the protruding tab on the end caps when the belt is properly tensioned. The washers will be positioned deeper into the end cap and not be as visible.
Checking the Belt and Deck Surfaces — The running belt and deck should be checked periodically for any excessive wear. In an effort to make sure that the running belt operates properly, visually inspect the belt on a weekly basis to make sure that there are no tears or fraying in the belt material.
To inspect the edges of the belt, it is necessary to remove the motor cover and plastic side rails. Follow these steps:
Tools Required
•Phillips head screwdriver
•3/16" Allen wrench
•Dry towel
1.Turn the power off.
A.Turn the main power switch on the front panel to the off (O) position.
B.Unplug the treadmill from the power outlet.
2.Remove the motor cover and side rails.
A.Remove the two Phillips head screws that fasten the motor cover to the frame. Lift the cover and set it aside. This will allow you to remove the side rails. See Figure 2.
B.Using a 3/16” Allen wrench, remove the two button head screws on the sides of each side rail. See Figure 2.
C.Grasp the top edge of each side rail and pull up and away from the deck. This will enable you to see the deck and edges of the belt. It is not necessary to remove the side rails completely off the frame.
3.Check the belt and deck condition.
A.Look at the edges of the belt while you roll it by hand. If the belt has any rips or looks
Page
