Cybex International LT-14464-4 Rev H Electrical Power Requirements, Unpacking, Hardware Bags

Cybex 710T Treadmill Owner’s Manual

vapor, chlorine, and/or bromine could adversely affect the electronics as well as other parts of the machine.

A comfortable environment will help you enjoy your exercise routine and give you additional motivation to continue.

Electrical Power Requirements

This treadmill is for use on a grounded, dedicated circuit, and one of the following: 115 VAC, 60 Hz and 20 amps, or 230 VAC, 60 Hz, and 15 amps, or 220/240 VAC, 50 Hz and 15 amps. Contact your electrician if you have any doubts about your electrical service.

Do not use a ground plug adapter to adapt the 3-prong power cord plug to a non-grounded electrical outlet. Do not use an extension cord.

Unpacking

Unpack and remove the treadmill parts from the shipping container. Leave the base in the box at this time. Leave the hardware in the bags at this time. Check for the following parts. See Figure 1. If any of the parts are missing contact your Cybex dealer.

•Base

•Uprights (left and right)

•Console assembly

•Cross brace

•Motor cover

•CR lower electronics PCB and panel assembly

•Front wheels (2)

•Owner's Operating Manual with registration card (1, not shown)

Hardware Bags

•Phillips head screws#6-32 x .50 for the front motor cover (2)

•Button head screws 5/16-20 x .75 for assembly (16)

•Star washers 5/16 (16)

•Allen wrench (Hex key), 3/16”

•Wire ties (2)

•Rubber foot pads (2, not shown)

Tools Required

•Phillips head screwdriver

•Allen wrench 3/16” (supplied)

5 Setup & Assembly

Quick Setup . . . . . . . . . . . . 5-1

Choosing & Preparing a Site 5-1

Electrical Power

Requirements. . . . . . . . . . 5-3

Unpacking . . . . . . . . . . . . . . 5-3

Assembling the Treadmill. . . 5-4

Testing the 710T Operation . 5-9

Setting Operation Options. 5-10

Page 5-3