4.4.2 Menu Items and Values
The table below lists all the menu items and their possible values in the ‘Printer Setup Procedure’.
1) MEDIA TYPE | 2) SENSOR TYPE | |
Sets printing for either direct | Select the sensor type that matches your | |
thermal (no ribbon) or thermal | label stock. | |
transfer (ribbon) stock. | Possible Values: | |
Possible Values: | ||
* EDGE: (Gaps in media) | ||
* DIRECT THERMAL | ||
(REFL) REFLECTIVE: (Black Mark) | ||
THERMAL TRANSFER | ||
(CONT) CONTINUOUS: (No sensing) | ||
| ||
|
| |
3) PRESENT SENSOR | 4) CUTTER EQUIPPED | |
Enables/Disables the optional | Enables/Disables the optional Cutter | |
Present Sensor Assembly | Assembly | |
Possible Values: | Possible Values: | |
* NO | * NO | |
YES | YES | |
|
| |
5) SOP ADJUST | 6) PRESENT ADJUST | |
This sets the point to begin printing, | This command specifies an additional | |
relative to the | amount to advance the label after print. | |
edge as detected by the media | Possible Values: | |
sensor). | ||
| ||
Possible Values: | Range: 0 – 255; default = *128 | |
0 = close to edge | ||
Range: 0 – 255; default = *128 | ||
255 = furthest from edge | ||
0 = close to edge | ||
| ||
255 = furthest from edge |
| |
|
| |
7) BAUD RATE | 8) DATA BITS | |
Sets serial port baud rate to match | Set data word length to match host. | |
host. | Possible Values: | |
Possible Values: | ||
* 8 | ||
| ||
600 to 38.4k; default = *9600 | 7 |
| 19 |
