3.2Loading Media
1. Open the cover.
2. Push the Printhead Latch down and raise the Printhead Carrier Assembly.
3. Place a roll of media (labels facing up) on the Media Hub and insert them into the printer. Slide the Media Hub Flange with its smooth side towards media onto the Media Hub.
4. Route the media as shown below.
5.Slide the Media Guide and Hub Flange to the edge of the media.
6.Close the Printhead Carrier Assembly and press down until it locks into place.
7.Close the cover and press the ‘Feed’ button several times to feed the media and ensure proper tracking. If the printer does not correctly sense the top of each label it may be necessary to perform the Calibration Procedure, Section 4.6.
Note: The printer is factory set for
| 9 |
