Datamax E-4304 manual Internal Labels, Database Configuration and Dot Check Label

4.7Internal Labels

The following sections explain each of the printer’s internally generated test and configuration labels.

4.7.1 Database Configuration and Dot Check Label

To print the Database Configuration and Dot Check Labels:

With the printer on, loaded with media (at least 4 inches wide), and ribbon (if printing in thermal-transfer). Press the + buttons simultaneously to print the Database Configuration and Dot Check Label

Alternately, press and hold the button and turning the printer on, continue holding the F2 button until the PAUSED light turns off. Using this method will initiate the ‘Character Dump Mode’. Turn the printer off to terminate the ‘Character Dump Mode’.

The first label printed will be the Database Configuration Label, which lists the printer's configuration and status.

FRI AUGUST 024, 2001 19:29 236		CONFIGURATION
VER: ET4204 - 04.06 08/24/01		DIRECT THERMAL
BOOT 83-2329-04A		SERIAL PORT SELECTED
CODE 83-2325-04F		19.2; 8BITS
FONT 83-2337-01A		EDGE
CPLD 592157-01C		CONT FORM LENGTH__			0
INTERNAL FLASH MODULE PRESENT		PRESENT ADJUST____		127
SYSTEM RAM CHECKS____ GOOD		SOP ADJUST________		127
SYSTEM RAM SIZE___ 2015 KBYTES		TOF LOW___________			0	0
SYSTEM RAM AVAIL__ 1244 KBYTES		TOF DELTA_________		10		10
REG POWER SUPPLY__ YES		TOF GAIN__________		12		10
		OOS MAXVOLT_______			3	3
		LABEL ALIGNMENT___		NO
		ALIGN LENGTH______		100
		STOP LOCATION_____ HOST
INPUT VALUES		COUNTER INFORMATION
PAPER_____________ 255		ABSOLUTE VALUES 6-18-2001
DARKNESS__________ 131		LENGTH____	773		INCHES
TRAN______________ 255		TIME______	20		HOURS
REFL______________ 149		RESETTABLE VALUES 6-22-2001
RIBN______________	87	LENGTH____	576		INCHES
TEMP______________	48	TIME______	10		HOURS
VOLT______________ 223		MEMORY CONFIGURATION
		INTERNAL MODULE______				15
		SCALABLE FONTS_______				32
		LABEL SIZE	0416:02157 IN

34 E-4203/E-4204/E-4304