•At the end of the chilling cycle, the appliance automatically switches to the set storage temperature for an indefinite interval (like a standard storage appliance).
LEDs 13 | switch off while LEDs 14 |
|
|
|
|
| light up. |
|
|
|
|
|
|
| |||||
• The compartment temperature is constantly shown on display 16; |
| οC during this cycle, defrost | |||||||
| |||||||||
| |||||||||
cycles are performed at regular intervals with duration set as required (parameter programming reserved for installation technician). The factory setting for positive storage temperature is +36°F / +2°C.
• Press |
| to set the appliance to STOP status (relative LED switches off), ready for a new |
| ||
cycle. |
|
|
To modify the final blast chilling temperature, consult the user programming instructions.
IMPORTANT: During chilling or shock freezing by core sensor it’s possible to read:
-The room temperature by pressing push button
-The evaporator temperature by pressing push button
5.3 SOFT TIMED BLAST CHILLING
• Press | +38ο | (relative LED lights up), then press | to select the timer mode | |
(LED 5B on). Display 15 | shows the maximum chilling time (set by default to 90 minutes). | |||
To modify this time, press 
and 8 
(time in minutes).
• Press | and |
flash throughout the cycle. |
|
Internal cell temperature is shown on display 16 | οC . |
•When the maximum chilling time has counted back to 0, the chilling cycle is completed and the appliance automatically switches to the set positive storage temperature for an indefinite interval.
•LEDs illuminate and the beep is activated when the cycle is finished (as in the chilling cycle by temperature). The same applies for the positive storage function.
Press 
to set the appliance to STOP status (relative LED switches off), ready for a new cycle.
IMPORTANT: Use the storage function sparingly. After chilling, food products should be placed in storage cabinets.
HARD BLAST CHILLING
When the HARD function is used, chilling takes place in two stages:
•an initial “Hard” stage when the air temperature is brought down to below 32°F / 0°C in order to accelerate chilling;
•a second “Soft” stage, involving air temperatures around 32°F.
IMPORTANT: During chilling or shock freezing by time it’s possible to read the evaporator temperature by pressing push button
