2.6 Condensate drainage connection
For models
2.7Information for the installation technician Before starting up the machine, check that it has been correctly installed.
1.Check that there are no gas leaks from weldings or joints made during installation works.
2.Check that the pipes connecting the condenser to the remote condensing unit have been well insulated.
3.Check all wiring connections.
4.Check electrical input.
5.Check the standard pressure in the refrigerant system.
6.Perform at least one blast freezing cycle (to the SET temperature) and one manual defrosting cycle. In the event that the appliance or
the remote condensing unit have not been transported in a vertical position (e.g. on the back) or have been overturned during installation works, allow at least 4 hours before starting up the equipment.
2.8Safety and control systems
•Door microswitch: shuts down fan operation in the cell when the door is opened.
•General fuses: protect the power circuit against short circuiting and overloads.
•Compressor heat relay: intervenes in the event of overloads or operating faults.
•Safety pressure switch: intervenes in the event of excessive pressure in the refrigerant circuit.
•Plug fuses: intervene in the event of verpressure or operating fault in the safety pressure switch (see above).
•Chamber temperature control: operated by the electronic board by means of a probe inside the cell.
•Temperature control end defrost cycle: controlled by the electronic board by means of the probe in the evaporator.
2.9Appliance disposal
After the useful life of the applicance has been realized, be sure to demolish and dispose of the machine in compliance with the regulations applied in the country of installation, particularly in regards to refrigerant gas and compressor lubricant oil.
