4Insert a plastic scribe into the guide on the side of the coin-cell battery compartment, and pop the battery out.

When you replace the battery, insert it at a 30-degree angle under the clip with the positive (identified by a plus [+] symbol) side up, and then push it into place.

Display

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the computer.

1Follow the procedures in "Before You Begin" on page 111.

2Remove the hinge cover. See "Hinge Cover" on page 122.

3Remove the six screws that secure the display (two on the top, two on the bottom, and two on the back).

4Disconnect the antenna cables from the Mini-Card.

Adding and Replacing Parts

129

Page 129
Image 129
Dell 1000 owner manual Display, 129