Dell 1000 - page 49

Using a Battery 49
• Depending on how you set the power management options on the
Advanced tab (see "Configuring Power Management Settings" on page 50)
in the
Power Options Properties window, use one of the following
methods:
– Press the power button.
– Close the display.
– Press <Fn><Esc>.
To exit standby mode, press the power button or open the display depending
on how you set the options on the Advanced tab. You cannot make the
computer exit standby mode by pressing a key or touching the touch pad.
Hibernate Mode
Hibernate mode conserves power by copying system data to a reserved area on
the hard drive and then completely turning off the computer. When the
computer exits hibernate mode, it returns to the same operating state it was
in before entering hibernate mode.
NOTICE: You cannot remove devices or undock your computer while your
computer is in hibernate mode.
Your computer enters hibernate mode if the battery charge level becomes
critically low.
To manually enter hibernate mode:
• C lick the Start button, click Turn off computer , press and hold <Shift>,
and then click
Hibernate .
or
• Depending on how you set the power management options on the
Advanced tab in the Power Options Properties window, use one of the
following methods to enter hibernate mode:
– Press the power button.
– Close the display.
– Press <Fn><Esc>.
NOTE: Some ExpressCards may not operate correctly after the computer exits
hibernate mode. Remove and reinsert the card (see "Removing an ExpressCard or
Blank" on page 61), or simply restart (reboot) your computer.
book.book Page 49 Tuesday, July 3, 2007 12:31 PM