Installing an Expansion Card
1. Follow the procedures in Before You Begin.
2. Gently push the release tab on the inside of the card retention door to pivot the door open. Because the door is captive, it will remain in the open
position.
3. If you are installing a new card, remove the filler bracket to create a card-slot opening, then continue with step5.
4. If you are replacing a card that is already installed in the computer, remove the card.
If necessary, disconnect any cables connected to the card. Grasp the card by its top corners, and ease it out of its connector.
5. Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your
computer.
6. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
7. Before you close the card retention door, ensure that:
lThe tops of all cards and filler brackets are flush with the alignment bar.
lThe notch in the top of the card or filler bracket fits around the alignment guide.
1
release tab
2
card retention door
CAUTION: Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.
1
bracket within slot
bracket caught outside of slot
3
alignment bar
4
alignment guide
fully seated card
6
not fully seated card