Check Printer Tray Alignment to the Picker
For the Desktop 4500 autoloader to operate with the printer, the printer tray must be aligned to the picker. The printer adjustment plate is factory adjusted but it may move after shipment. Therefore, it may be necessary to check the printer alignment after installation. All of the cables must be connected and the Liberty Printer Driver and Tray Controller application must be installed before performing this procedure. The Tray Controller is installed when the printer driver was installed.
Required Tools
•T10 Torx screwdriver
•5/32” Allen wrench
•Disc
1.Power on the Desktop 4500 and the PC if you have not already done so.
2.Log on if you have not already done so.
3.If the connected PC has the Rimage OfficeNet Software Suite installed, wait for the Production Server to complete the configuration process before aligning the printer tray. If the Software Registration screen appears, select Cancel.
Close the Production Server application if it is running.
4.Rotate the leadscrew clockwise to move the picker to the top of the picker column.
1 – Picker | 2 – Leadscrew |
|
|
5. Press a disc into the picker as shown.
27 | Installation |
